433 Mhz Remote Control Universal Wireless Remote Switch AC 220V 30A Relay Receiver 1000m RF Transmitter for water pump / Farm

Product Application Area
Products can be used in homes, farms, factories, offices, laboratories, supermarkets and so on.
Remote control garage door \  Electric door \ house door \ shutter door \ expansion door \ gate door \ road gate
Remote control Electric curtain \ Water pump \ Fan \ Lamp \ LED light \ bulb \ ventilation device \ Signal transmission
Remote control motor positive and negative rotation \  motor switch \ DIY

Relay Receiver Board Parameter

• Working voltage  :  AC90V-250V

• Input/Outputvlotage  :  1~250V

• Quiescent Current  :  <5MA

• Max current  :  30A

• RF frequency  :  433MHz

• Working temperature  :  -30~+80 degrees

• Receiving Sensitivity  :  >97dbm

• Amount of storage remote controls  :  20 pieces

• Support encoding  :  1527 Learning code /2262 fixed code

• RF Operating mode  :  ASK superheterodyne wireless reception

• Receiving range  :  Open space is more than 3000 meters

• Remote operating mode   : Momentary Mode / Toggle Mode / Latched Mode

Remote Control Parameter

• Size  :  97*40*16mm

• Battery:  23A 12V

• Launching distance : 500M (open distance)

• RF frequency  :  433MHz

• Support encoding  :  1527 Learning code /2262 fixed code

Working Modes
You can set up in 3 modes: Momentary mode,Toggle mode and Latched mode.
Momentary mode:
Press and hold A button,thisrelay will work;Release A button,this relay will stop.
Toggle mode:
Press A button,the relay will work;press A button again,thisrelay will stop.
Latched mode:
Press A button,the relay will work;press B button again,this relay will stop,second relay will work.
How to Set up
Momentary mode:
Press learning button once,press A button once,succeed.
Toggle mode:
Press learning button twice,press A button once,succeed.
Latched mode:
Press learning button 3times, press A button once,press C button once,press B button once,succeed.
Reset:
Press learning button 8times,the data will be cleaned.All remotes cannot control this receiver.
If u want to change modes,u need to clean the data first.